热固性自膨胀堵调体系的物理模拟实验研究与应用
The Application and Research about the Physical Simulation of the Thermosetting and Self-Expansion Water Shutoff System

作者: 罗立文 :中国石油大学(华东)理学院; 侯宝峰 :中国石油大学(华东)化学工程学院; 曹嫣镔 * , 何绍群 :胜利石油管理局采油研究院稠油所;

关键词: 岩心流动实验封堵压差水相渗透率封堵率物理模拟实验Core Flow Experiment Sealing Pressure Difference Water Permeability Plugging Rate Physical Simulation Experiment

摘要: 相关研究人员通过岩心流动物理模拟实验的方法,采用岩心驱替模型,通过监测实验过程中压力变化,来评价堵调体系在岩心中成胶后的封堵压差及水相封堵率,为现场应用提供参考。通过实验发现:当其它条件一定时,糠醇含量越高,封堵压差越大;成胶温度越高,封堵压差越小;堵前水相渗透率越大,固结后封堵压差越小。当其它条件一定时,封堵压差与岩心管的长度基本上是呈线性关系的,且岩心管越长,封堵压差越大。优化后的堵调体系在较低的浓度下,当处于高温时仍有很好的封堵强度,对不同渗透率的岩心均有良好封堵适应能力,其封堵率均在99.0%以上。在现场进行先导试验之后,堵调体系也取得了良好的降水增油效果。

Abstract: Through the core flow experiment, the core displacement model was applied to monitor the pressure changes in the process of experiments to evaluate the block pressure difference and water plugging rate after the water shutoff system gel in cores, thus, it can provide a reference for field application. Found by experiment: the higher furfuryl alcohol content, the greater the block pressure difference; the higher the gelling temperature, the smaller the block pressure difference; the greater the aqueous phase permeability before the block of stratum, the smaller the block pressure difference after consolidation. When other conditions remain the same level, the block pressure difference and the length of the core tube is basically a linear relationship. The water shutoff system optimized in the lower concentration still has good sealing strength when exposed to high temperatures. As to the core of different permeability, it still has a good blocking ability and its blocking rate is 99.0% or higher.

文章引用: 罗立文 , 侯宝峰 , 曹嫣镔 , 何绍群 (2012) 热固性自膨胀堵调体系的物理模拟实验研究与应用。 化学工程与技术, 2, 126-131. doi: 10.12677/HJCET.2012.24023

参考文献

[1] 张力平. 改性呋喃树脂的研究[J]. 陕西化工, 1994, 26(4): 16- 17.

[2] 段友智. 稠油热采化学调驱复合体系研究[D]. 中国石油大学(华东), 2010.

[3] 申德勇. 热–化学复合驱提高稠油采收率机理的实验研究[D].中国石油大学(华东), 2011.

[4] 刘一江, 王香增. 化学堵水技术[M]. 北京: 石油工业出版社, 1999: 2-4.

[5] 戴彩丽, 冯德成, 高恒达等. 高效洗油剂吞吐与油井堵水结合技术研究[J]. 油田化学, 2005, 22(3): 248-251.

[6] P. P. Hess. One-step furfuryl alcohol proc-ess for formation plug- ging. Journal of Petroeum Technology, 1980, SPE-8213: 1834- 1842.

[7] 樊剑, 韦莉, 韩冬等. 聚合物驱后原位交联提高采收率的物理模拟研究[J]. 油田化学, 2011, 28(3): 323-326.

[8] 李科星, 邓秀模, 钱志鸿等. JSF-1复合调剖体系的研制与应用[J]. 油田化学, 2010, 27(4): 411-415.

[9] 张贵才, 何小娟, 蒋平等. 腐殖酸高温堵水剂的制备及评价[J]. 石油与天然气化工, 2006, 35(4): 307-309.

分享
Top