基于半功率带宽法的薄板涂层结构阻尼特性测试
Damping Measurement of Thin Coating Plate Based on Half Power Method

作者: 朱全军 :全球能源互联网研究院,北京; 樊习英 :国网山西省电力公司经济技术研究院,山西 太原; 曹枚根 :中国电力科学研究院,北京; 韩清鹏 , 任建兴 :上海电力学院能源与机械工程学院,上海;

关键词: 半功率带宽法薄板涂层结构阻尼特性测试Half Power Method Thin Coating Plate Damping Measurement

摘要: 本文主要研究了薄板-涂层结构系统的阻尼特性的测试方法与典型案例。首先介绍了半功率带宽法的识别原理,在此基础上,搭建了用于半功率带宽法测试的实验系统。采用半功率带宽法识别了带有涂层的钛基薄板结构的阻尼特性。针对涂覆TiZrN涂层前后的钛基薄板进行了阻尼特性测试,获得了系统的阻尼特性参数。对比所得的测试结果表明,薄板结构涂层后系统的固有频率发生了错频,且阻尼特性明显增大。

Abstract: The damping characteristic of thin plate coat structure was studied in this paper. Recognition algorithm of half power bandwidth method was first introduced, and then the measurement experimental system was established. The damping characteristic of titanium membrane of thin plate was recognized by the half power method. The damping characteristic of titanium membrane of thin plate coated with TiZrN was measured. The parameters of damping system were estimated. The natural frequency of coated thin plate mistuned and the damping characteristic amplified obviously.

文章引用: 朱全军 , 樊习英 , 曹枚根 , 韩清鹏 , 任建兴 (2017) 基于半功率带宽法的薄板涂层结构阻尼特性测试。 机械工程与技术, 6, 34-38. doi: 10.12677/MET.2017.61005

参考文献

[1] Blackwell, C., Palazotto, A., George, T.J. and Cross, C.J. (2007) The Evaluation of the Damping Characteristics of a Hard Coating on Titanium. Shock and Vibration, 14, 37-51.
https://doi.org/10.1155/2007/260183

[2] 胡卫强, 王敏庆, 刘志宏, 马少璞, 周赤奇. 机械结合面动态特性测试与仿真[J]. 机械科学与技术, 2016, 35(2): 320-324.

[3] 李锐锐, 虞志浩, 杨卫东, 武珅. 直升机旋翼黏弹阻尼器时域动力学建模与分析[J]. 航空学报, 2015, 36(6): 1905-1912.

[4] 翁震平, 席亦农. 相关分析在结构阻尼比时域衰减法测量中的应用[J]. 船舶力学, 2009,13(4): 347-350.

[5] 杨莉, 孙庆鸿. 自由阻尼处理结构的有限元建模及声辐射分析[J]. 振动工程学报, 2004, 17(3): 306-309.

[6] 淡丹辉, 孙利民. 结构动力有限元的模态阻尼比单元阻尼建模法[J]. 振动、测试与诊断, 2008, 28(2): 100-103.

分享
Top