基于ANSYS的机械密封环开槽对比分析
Comparative Analysis of Sealing Ring Slot Machines Based on ANSYS

作者: 李 婕 :天地科技股份有限公司,开采设计事业部,北京;

关键词: 机械密封过盈联接开槽有限元分析Mechanical Seal Interference Fit Slotting Finite Element Analysis

摘要:
为分析机械密封环开槽对机械密封性能的影响,通过对机械密封环的结合面不开槽、以及分别在静环和静环座开槽三种情况进行有限元分析,查看运转工况下的应力场、结合面接触压力、密封端面轴向变形、温度场分布。根据对密封性能的影响,确定合理的开槽情况。通过分析发现,开槽比不开槽的密封性能好,在静环座开槽的密封性能最好。

Abstract: In order to analyse the effect of making slots on sealing performance of mechanical seals, according to three finite element analysis, including no slotting in mechanical sealing ring of interference fit face, making slots in stationary ring and stationary ring base, the operation conditions of stress field, contact pressure of interference fit surface, the end face axial deformation, temperature dis-tribution are drawn. Based on the effect on sealing performance, a reasonable slot situation is de-termined. Through the analysis it is found that slotting is better than no slotting over the sealing performance; making slots in stationary ring base has the best sealing performance.

文章引用: 李 婕 (2016) 基于ANSYS的机械密封环开槽对比分析。 机械工程与技术, 5, 83-94. doi: 10.12677/MET.2016.52011

参考文献

[1] 谢龙滨. 镶嵌式硬质合金环变形的原因及预防[J]. 电碳, 1989(1): 15-17.

[2] 廖和滨. 机械密封环温度场/应力场的数值模拟及实验研究[D]: [硕士学位论文]. 福州: 福州大学, 2005.

[3] 杨世铭, 陶文铨. 传热学[M]. 北京: 高等教育出版社, 2006: 250-251.

[4] 朱学明, 刘正林, 朱汉华, 胡社来. 机械密封环热–结构耦合分析研究[J]. 武汉理工大学学报, 2005, 29(2): 198-201.

分享
Top