垂直井筒中多相流动的Beggs-Brill压力梯度预测模型的改进
Modification of Beggs-Brill Pressure Gradient Predicting Model for Multiphase Flow in Vertical Wells

作者: 董 勇 :长江大学信息与数学学院,湖北 荆州; 教育部油气资源与勘探技术重点实验室(长江大学),湖北 荆州; 李梦霞 :长江大学信息与数学学院,湖北 荆州; 教育部油气资源与勘探技术重点实验室(长江大学),湖北 荆州; 长江大学石油工程学院,湖北 武汉; 廖锐全 :教育部油气资源与勘探技术重点实验室(长江大学),湖北 荆州; 长江大学石油工程学院,湖北 武汉; 罗 威 :教育部油气资源与勘探技术重点实验室(长江大学),湖北 荆州; 长江大学地球科学学院,湖北 武汉;

关键词: 多相流压力梯度预测Beggs-Brill模型Multiphase Flow Pressure Gradient Prediction Beggs-Brill Model

摘要:

Beggs-Brill模型是具有代表性的压力梯度计算模型,但存在预测的多相管流压力梯度偏差过大的问题。通过对比Beggs-Brill模型的预测误差与试验设置的参数,认为Beggs-Brill模型预测误差与气液比参数关系密切,建立了Beggs-Brill模型预测误差关于气液比的二次回归模型,并结合该回归模型与Beggs-Brill模型,建立了一种新的压力梯度预测方法,即BBM模型。对90组试验数据的处理结果表明,BBM模型的预测平均相对误差为6.07%,而Beggs-Brill模型的预测平均相对误差为21.56%。以试验中含水率30%、90%的情况为已知数据,采用BBM模型预测含水率60%时的压力梯度,与试验测试压力梯度比较的平均相对误差为15.86%,比Beggs-Brill模型提高了3.7%。BBM模型提高了多相管流压力梯度预测的精度,有助于提高油气井设计和分析的可靠性。

Beggs-Brill Model was a representative one for calculating pressure gradient. There was a large difference between the pressure gradient calculated by Beggs-Brill method and the pressure gradients measured in experiments of multiphase flow in vertical tubing. By comparing the predicting deviations between Beggs-Brill model and experimental apparatus, it was considered that the predicted deviation using Beggs-Brill Model was closely related with the parameters of gas-liquid ratio. And then combining the correlation method with Beggs-Brill Model, a two-regression model based on the deviation of Beggs-Brill Model was established, and in combination with the 2 models, a new pressure gradient predicting method named BBM model was built. The results for 90 groups of experimental data show that the average relative error of BBM method is 6.07% and the one of Beggs-Brill method is 21.56%. Based on the known data with 30% and 90% water contents, BBM model is to predict the pressure gradients at 60% water content, and compared with the BBM gradients with the experimental pressure gradient, the average relative error of BBM modle is 15.86%, which is 3.7% higher than that of Beggs-Brill model. The results show that the BBM model improves the predicting precision of pressure gradient for multiphase flow in vertical wells; it is beneficial for improving the reliability of design and dynamic analysis of oil and gas wells.

文章引用: 董 勇 , 李梦霞 , 廖锐全 , 罗 威 (2016) 垂直井筒中多相流动的Beggs-Brill压力梯度预测模型的改进。 石油天然气学报, 38, 40-47. doi: 10.12677/jogt.2016.381006

参考文献

[1] 周瑞立, 周舰, 罗懿, 等. 低渗产水气藏携液模型研究与应用[J]. 岩性油气藏, 2013, 4(4): 123-128.

[2] 田相雷, 蒋海岩, 岳艳如, 等. 气举排水采气生产规律研究[J]. 断块油气田, 2013, 19(6): 760-763.

[3] 白晓弘, 田伟, 田树宝, 等. 低产积液气井气举排水井筒流动参数优化[J]. 断块油气田, 2014, 21(1): 125-128.

[4] 田云, 王志彬, 李颖川, 等. 速度管排水采气井筒压降模型的评价及优选[J]. 断块油气田, 2015, 22(1): 130-133.

[5] Musaab, M.A. and Ayoub, M.A. (2014) A Comprehensive Study on the Current Pressure Drop Calculation in Multiphase Vertical Wells; Current Trends and Future Prospective. Journal of Applied Sciences, 14, 3162-3171.
http://dx.doi.org/10.3923/jas.2014.3162.3171

[6] Beggs, D.H. and Brill, J.P. (1973) A Study of Two-Phase Flow in Inclined Pipes. Journal of Petroleum Technology, 25, Document ID: SPE4007.
http://dx.doi.org/10.2118/4007-pa

分享
Top