一种基于六端口的双频接收方法
A Dual-Band Receiving Approach Based on Six-Port

作者: 张洪峰 :杭州电子科技大学通信工程学院,浙江 杭州;

关键词: 六端口网络六端口电路双频解调校准方法Six-Port Network Six-Port Circuit Dual-Band Demodulation Calibration Methods

摘要:
介绍了一种基于六端口的双频信号接收方法。在射频六端口网络工作的频率范围内,使用一个合适的校准方法可以同时下变频两个射频信号,这两个射频信号可以是不同调制方式、不同带宽、不同标准的射频信号。文中推导了该方法的数学模型,并通过实验仿真验证了该方法对16QAM和64QAM信号的解调性能,仿真得到的误比特率(BER)和误差矢量幅度(EVM)表明该方法具有较好的信号解调性能。与传统的双频接收机相比,六端口电路易于MMIC集成,支持的带宽更宽,没有多余的下变频支路,可以用在多种无线电应用中。

Abstract: This paper introduces a two-frequency signal receiving method based on the six-port. Using a suitable calibration method can down convert two different RF signals at the same time; these two RF signals can be with different modulation mode, different bandwidth and different standards of RF signals. This paper deduces the mathematical model of this method, and this method is verified by the performance simulation of 16QAM and 64QAM signal demodulation. The bit error rate (BER) and error vector magnitude (EVM entry) obtained from simulation show that the method has a better signal demodulation performance. Compared with the conventional dual-band receiver, six- port circuit is easy to MMIC integrated, the bandwidth is wider, there is no redundant frequency conversion, and it can be used in many radio applications.

文章引用: 张洪峰 (2015) 一种基于六端口的双频接收方法。 电路与系统, 4, 32-37. doi: 10.12677/OJCS.2015.42005

参考文献

[1] Hashemi, H. and Hajimiri, A. (2002) Concurrent multiband low-noise amplifiers theory design and applications. IEEE Transactions Microwave Theory Technique, 50, 288-301.

[2] Wang, Y.J., Jeon, S. and Babakhani, A. (2008) A 6 to 18 GHz tunable concurrent dual-band receiver front end for scalable phased arrays in 130 nm CMOS. IEEE Radio Frequency Integrated Circuits Symposium, Piscataway, 343- 346.

[3] He, Q., Liu, Y.-A., Li, S.-L., Yu, C.-P., et al. (2011) The concurrent dual-band receiver architecture with one mixer. The 3rd Pacific-Asia Conference Circuits Communication and System (PACCS), Wuhan, 17-18 July 2011, 1-4.

[4] 胡晓 (2007) 六端口直接QPSK调制器. In: 2007年全国徽波毫米波会议论文集, 电子工业出版社, 北京, 1469- 1471.

[5] 张兰, 王兵, 冯科锦 (2005) 射频六端口网络在软件无线电中的应用. 通信学报, 9, 79-84.

[6] 吴利楠, 张旭春 (2010) 六端口技术的发展与应用. 电讯技术, 5, 108-113.

[7] Bugo, T., Klippenstein, B., Saizew, M., et al. (2010) Dual band receiver using passive six port down conversion technique suitable for multi standards and SDR applications. Proceedings of Asia-Pacific Microwave Conference, Yokohama, 7-10 December 2010, 1312-1315.

[8] Owais, J.Ö., Karlsson, M., Serban, A., et al. (2011) Direct carrier six port modulator using a technique to suppress carrier leak age. IEEE Transactions Microwave Theory Technique, 3, 741-747.

[9] De la Morena-Álvrarez-Palencia, C. and Burgos-García, M. (2011) Four-octave six-port receiver and its calibration for broadband communications and software defined radios. Progress in Electromagnetics Research, 116, 1-21.

[10] Hasan, A. and Helaoui, M. (2012) Novel modeling and calibration approach for multiport receivers mitigating system imperfections and hardware impairments. IEEE Transactions Microwave Theory Technique, 60, 2644-2653.

[11] Gomes, H., Testera, A.R., Carvalho, N.B., et al. (2011) Diode power probe measurements of wireless signals. IEEE Transactions on Microwave Theory Technique, 59, 987-997.

[12] de la Morena-Álvarez-Palencia, C. and Burgos-García, M. (2010) Broadband RF front-end based on the six-port network architecture for software defined radio. IEEE Military Communications Conference, 2010-MILCOM, San Jose, 31 October 2010-3 November 2010, 2137-2142.

分享
Top