不同汽源参数对船用蒸汽蓄热器充汽过程影响的数值研究
Numerically Investigating Influence of Different Steam Source Parameters on Charging Process of Marine Steam Accumulator

作者: 吴廉巍 :海军驻武汉701所军事代表室,武汉; 杨元龙 :中国舰船研究设计中心,武汉;

关键词: 船用蒸汽蓄热器充汽过程汽源参数数值研究Marine Steam Accumulator Charging Process Steam Source Parameter Numerical Simulation

摘要:
采用考虑汽液两相蒸发与冷凝的两流体模型和热相变模型,基于不同充汽流量和温度耦合的边界条件,进行了不同汽源参数下船用蒸汽蓄热器充汽过程数值模拟,分析了不同充汽流量和温度对蒸汽蓄热器充汽过程动态特性的影响。计算结果表明,充热能量一定条件下,充汽温度越高,蓄热器内部蒸汽温度越高,温度场和速度场分布越不均匀;充汽流量降低,蒸汽射流效应更加强烈。

Abstract: Two-fluid model and thermal change model with considerations of evaporation and condensation for vapor and liquid were utilized. Based on the coupled boundary conditions with different charging flow rates and temperatures, numerical investigation on the influence of different steam source parameters on charging process of marine steam accumulator was carried out. Effects of different charging flow rates and temperatures on the dynamic characteristics of charging process for steam accumulator were analyzed. The calculated results showed that higher charging tem-perature resulted in higher temperature for steam in an accumulator in the term of certain charging energy per unit time, causing nonuniform temperature and flow field. Lower charging flow rate could cause stronger steam jet.


Abstract:

文章引用: 吴廉巍 , 杨元龙 (2014) 不同汽源参数对船用蒸汽蓄热器充汽过程影响的数值研究。 应用物理, 4, 169-175. doi: 10.12677/APP.2014.410020

参考文献

[1] 胡继敏, 金家善, 严志腾 (2012) 汽源参数变化对储汽筒充汽系统变工况性能的影响. 海军工程大学学报, 5, 102-107.

[2] 孙宝芝, 郭家敏, 雷雨 (2013) 船用蒸汽蓄热器非平衡热力过程. 化工学报, S1, 59-65.

[3] 胡继敏, 金家善, 严志腾 (2012) 储汽筒充汽系统的热力过程建模与仿真. 上海交通大学学报, 4, 545-549.

[4] 胡继敏, 金家善, 严志腾 (2012) 船用蒸汽蓄热器快速充汽过程吸热特性的测量方法研究. 船舶工程, S2, 55-59.

[5] Vladimir, D.S., Blazenka, M. and Sanja, P. (2012) Dynamics of steam accumulation. Applied Thermal Engineering, 37, 73-79.

[6] Yang, Y.L., Sun, B.Z. and Li, Y.J. (2013) CFD investigation of thermal-hydraulic cha-racteristics for a steam generator with and without tube support plates. Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 31, 358-365.

[7] Sun, B.Z. and Yang, Y.L. (2013) Numerically investigating the influence of tube support plates on thermal-hydraulic characteristics in a steam generator. Applied Thermal Engineering, 51, 611-622.

分享
Top